I will be recycling the square display stand that came with the Gopro that's the main piece of this project.
Things you need -
GoPro square stand - came with your camera A standard 1/4 inch nut - .25 cents each from local hardware store Loctite 6 minute epoxy gel - $4.99 Instant glue - .99 cents Duct tape or masking tape Saw or cutter Sandpaper
First step is to apply tape on the top to cover the holes firmly.
Second step is turn over the stand and place your 1/4 nut in the center and add instant glue.Let it dry for a minute.
Start mixing the epoxy, you need a small amount maybe a size of a quarter to start.
Third step pour the mixed epoxy inside the cavity then let it dry for 6 minutes. ( if you have 6 minute epoxy)
Repeat this process unit it gets even on the top. Avoid pouring the epoxy into the 1/4 nut hole.
Fourth step cut the edge around the mount and TAKE YOUR TIME when you do this. Use the sandpaper to finish the jagged edges and the bottom part of the mount.
Here's the finished Gopro Diy tripod mount mod.
Here's my Gopro mounted on the bendy Gorilla tripod.
I certainly had fun doing this Diy GoPro tripod mount mod project even though their available online but, the accomplishment is always rewarding, I hope you feel the same too enjoy.